Split Rail Fence Installation
Split Rail Fence Installation is among the oldest fencing methods that was used by people to fence their homesteads. Anyone living close to forests should find it important learning, the procedure for split rail fence installation. This is because, the enclosure is usually found in forested area due to the fact that it makes most of the readily available materials in the wooded area.
Although the method is archaic, it is beautiful and conspicuous especially to those who have not lost touch to tradition. It is simple, economical and generally strong. The installation is also unpretentious because it uses basic tools such as, an axe, wedge, helmet and a pair of gloves. Most importantly, the method is essential in recycling inoperative timbers and producing a useful, as well as attractive enclosure.
Procedures Used To Successfully Build A Split Rail Fence Installation
Establish where the Split Rail Fence Installation is to be installed. Make sure the place is safe and sound for one to excavate. Ensure gas, water and power line are not right underneath the area you are supposed to dig up holes. The lines can be extremely dangerous and harmful to the workforce and anyone around.
First, measure the perimeter of the area you want to enclose. The boundary line should be marked clearly to avoid confusion. To do this, mark all the corners using ground stakes and make a discernible outline by tying a guideline from one corner to another. In essence, this guarantees you a straight and well-stretched line.
With the guideline still in position, set your corner posts. Dig up a hole to plant the split posts depth. The depth of the burrow depends on the size of the post and the height of the enclosure. To be precise, it should accommodate a third of the total length of the post. Under normal circumstances, put the concrete to an appropriately of 24 inches deep and leave it to cure for a minimum of seventy-two hours. Set up your posts at approximate distance of 10 to 12 feet from each other. Now remove the guideline and make sure the posts are in straight line to each other.
Set up a guide wire and ensure the posts are vertically upright. The wire should run from one corner to the other at around 6 inches from the ground. The purpose of setting up the wire is to ascertain accuracy of the line both in dimension and smoothness.
Measure the length from post to post and cut your rail matching the length and size as of all rails as close as possible to maintain a spruce appearance. With the help of your axe and your wedge, split the post from top to bottom. You can make this Split Rail Fence Gate tips.
Make sure the split is wider at the at the top than at the bottom.
Lastly, take your hummer and drive nails through each split post and rail to join them. Caution must be taken to avoid splitting the post imperfectly to an extent that it cannot hold the rails strongly. If the procedure is carefully followed, the rails should fit tightly into the created wedge and form a perfect Split Rail Fence Installation. The fence is always strong enough to protect anything within from destruction as well as keeping the place knit and beautiful.